Mechanical Part

New Air Lift Load Lifter 5000 Ultimate Plus. Fits 94-2004 Ford, 89-2002 Dodge and

2024-12-02 05:50:32

4 Photos

82-1986 GM. Box is open but plastic bags inside with parts are unopened. Sold pickup I bought kit for

Glen Ullin, ND

$175

2024-11-30 12:20:32

Golden Valley, ND

2024-11-30 09:33:41

2004 4.3L motor and transmission and transfer case/Out of a Chevy blazer/100K orig

4.3L motor and 4L60E transmission and transfer case out of a 2004 blazer/1000k original miles/Everything ran great/)No problems/Vehicle was sideswiped/Motor comes complete, harness,ECM.

Bismarck, ND

$550

2024-11-26 22:41:27

Came off of a 1991 k3500 was in perfect working order, blew engine up, can deliver to Bismarck, also check out my other ads and get the info about dealing. Thanks for looking!

1991 Chevy Hydrboost

Carson, ND

$135 OBO

2024-11-26 22:34:54

1991 k3500 front driveshaft

Parting out pickup, blown engine, perfect condition including joints, throw it on and go. Like I said in a couple of my other ads, I will trade mostly for coins and guns

Carson, ND

$200

2024-11-26 20:25:49

2015 6.0 complete engine. Motor is seized, no idea why. Perfect for a LS rebuild/

swap. $300obo

Minot, ND

$300

2024-11-24 17:01:38

1999 7.3 PS 4R100 transmission w/ T-CaseGood working automatic transmission with e

lectric shift transfer case. Everything worked great as I used it for pulling a stock trailer Doing a manual swap

Harvey, ND

$2,000 OBO

2024-11-24 14:05:43

6.0 Powerstroke Injectors

Set of 8 brand new Ford Motorcraft reman injectors for 03.5-07 6.0 Powerstroke

Kenmare, ND

Contact for Price

2024-11-24 00:34:28

Ford 5.4 liter passenger exhaust manifold kit

Have studs and nuts that mount it to the head also. Brand new $70 for all

Bismarck, ND

$70

2024-11-23 17:28:05

OBD-II module for Dakota Digital dash. Was going to use for my LS swap project bu

t went a different route. Can meet In Bismarck weekdays. Dakota Digital OBD-II/CAN InterfacesDakota Digital OBD-II/CAN

Washburn, ND

$100 OBO

2024-11-22 06:39:54

Manton Series 4 Pushrods 3/8”x.145” Wall 8.200” length. Have 5/16” tips on

each end. Set of 8. Brand new just ordered the wrong length.

Nortonville, ND

$150

2024-11-17 10:35:46

Comp Cams Hydraulic Roller Lifters for chevy roller blocks. Part # 850-16.Never ra

n only used to assemble valve train for mock up.

Bismarck, ND

$150

2024-11-17 10:35:42

Comp Cams hi tech push rods 7.300 length .080 wall part# 7949-16. Used about 5,000

miles

Bismarck, ND

$40

2024-11-17 10:35:27

Used Cloyes Hex-A-Just timing chain for SBC with factory roller cam. Part # 9-3145

. Has about 5,000 miles on it.

Bismarck, ND

$40

2024-11-16 09:22:54

88/83 T4 turbo, never ran

Brand new turbo, sold car I was going to use it for. Need gone, make me a decent offer and come get it.

Bismarck, ND

$400

2024-11-14 21:34:41

Front cv half shafts for 2001 jeep grand cherokee with 4.7 liter QUADRA DRIVE

Front cv half shafts for 2001 jeep grand cherokee with 4.7 liter engine with QUADRA DRIVE transfer case, other years will work just not sure which ones (you can look it up, i dont want to be responsible.)

Minot, ND

$80

2024-11-14 00:08:51

Chevy sbc 3998991 heads Cleaning out shed 150obo

Chevy sbc 3998991 heads Cleaning out shed 200obo

Mandan, ND

$150

2024-11-14 00:08:46

2 Ford 351W flex plates Is what I was told Dont know a lot about ford parts cleani

Mandan, ND

2024-11-14 00:08:39

Casting is E5AE-CA on all 4One head lost a valve seat Cleaning out shed

Mandan, ND

2024-11-14 00:08:13

2 351W crankshafts Ones a 2 piece other is a 1 piece rear seal $300 OBO

Mandan, ND

$300

2024-11-12 16:18:44

4 Photos

6 cylinder Was completely overhauled at Dales Auto Restoration. Only has 500 miles

on it.New radiator, a/c compressor, carburetor, and starter. Everything is brand new and on the engine, ready to

Garrison, ND

Contact for Price

2024-11-10 08:14:14

1969 Camaro Rhodes Race Cars 18-3104 Fuel Tank with Sump. 0-90ohm sending unit. Co

mes with mounting straps also. Bought and realized it only fits 1969 so it didn’t fit our application. Brand new

Nortonville, ND

$400

2024-11-08 16:52:54

Acura J32a3 engine and 5AT trans. Pulled from 2006 Acura TL ASPEC. 166,7xx miles

but engine was rebuilt around 120k I believe when the serpatine belt got wrapped in the timing belt. I have videos

Bismarck, ND

$400 OBO

2024-11-06 14:45:05

5 Photos

2 new door actuators for 2001-2007 caravan or grand caravan sliding rear passenger

and drivers side doors Sell as a pair.

Bismarck, ND

$25

2024-11-05 20:24:29

Gen 1 coyote core engine, had a rod knock. Make an offer would make a great rebuil

der. Gonna need new valve covers and intake manifold

Mandan, ND

Make an Offer

2024-11-05 19:32:48

Aluminum sbc parts $225Pulleys with belt and hardware Caters fuel pump with bracke

t Alternator with bracketValve covers with gaskets

Steele, ND

2024-11-03 08:54:50

3 core radiator from a manual trans 1983 c2500. I used this as is however the top

hose port could use a re solder. Dimensions of the finned area are:28.5 wide19.75 tall1.5 thick3 coreLeft side top

Washburn, ND

$100 OBO

2024-11-02 12:18:32

4 Photos

SM465 trans from a 83 c2500. I LS swapped this pickup and must not have adjusted

something right because the clutch plate blew up after only 5000 miles. So I pulled the whole trans and installed

Washburn, ND

2024-10-25 13:31:31